PLANET ICS-102 - Manual (Page 48)

User’s Manual of ICS-10x
-43-
The ICS-10x’s “telnet server mode”--if the user used the MS-DOS telnet command it will
show double character. So the user can use other Telnet software like: “putty” or “NetTerm”.
Example 1: Telnet Command in Windows Platform
Figure 4-39 Example Telnet Server
Setup Operation Mode and Serial Port of ICS-10x
1. Set the ICS-10x mode to “Telnet server mode” from web interface.
2. Set the Serial Port Configuration of ICS-10x as below:
Mode: RS-232
Baudrare: 9600
Character Bits: 8
Parity Type : none
Stop Bit : 1
Hardware Flow Control: none
Execute “Telnet” command from Windows Start Menu
3. Click the Start Menu and go to Run
4. Type "telnet" without the quotes and hit enter.