PLANET ICS-102 - Manual (Page 31)

User’s Manual of ICS-10x
-26-
When DHCP Client is set to Enable, the IP Address, Subnet Mask, Gateway and DNS fields are not
allow to be changed.
If the ICS-10x is set to DHCP Client enable, you can use PLANET Smart Discovery or PLANET
VCOM Utility to search the ICS-10x which with DHCP assigned IP address.
4.4 Operation Mode
The ICS-10x make connected Serial equipment becomes IP-based. That also makes them be able to connect to a TCP/IP
networking immediately. The ICS-10x allow traditional Computer/Client COM ports access to a serial equipment
anywhere on the Ethernet LAN network.
This Operation Mode configure page allows setup Serial interface operation mode as below:
 TCP Server
 TCP Client
 UDP Client
 Virtual COM
 Telnet Server
 Pair Connection – Local(Master)
 Pair Connection – Remote(Slave)
Figure 4-11 Operation Mode Configuration screen
Select the operation mode for the application and press the “Apply” button to take affect.