PLANET EPL-1000 - Manual (Page 14)

1
EPL-1000 GUI Personality Setup
The EPL-1000 supports a 10/100Mb Management interface for User-Friendly
GUI Management. Prior to installing the GUI, it may be necessary to modify the
Host and Management IP addresses configuration stored in the OLT personality
flash. It can either be left as the defaults or changed to suit your own network
environment.
You can see what the current settings are by typing the following commands.
Commands shown below must be entered at the Tera Term command prompt for
the EPL-1000.
1) 3721/>pers [Enter]
2) 3721/pers/>show [Enter]
This will result in information about the state of the personality flash being
displayed. The items near the end of the prints are the current Management
Interface Settings. Typically the factory settings are:
Management interface settings:
Physical interface: ethernet
Management VLAN: 4095
Transport protocol: udp
Local IP config: static
Host IP config: static
Host IP: 192.168.1.100
Mgmt IP: 192.168.1.101
Netmask: 255.255.255.0
The Mgmt IP address refers to the IP address of the OLT 10/100Mb MGMT Port.
The Host IP address refers to the IP address of the PC which is running the GUI
Utility. The default settings are for both of these IP addresses to be statically
assigned. The netmask should be set to suit the class of the IP addresses. In
addition to the 10/100Mb MGMT Port, management can also be performed in-band.
In this case the MGMT Port is not connected. Instead the OLT is programmed for
in-band management and the user sets the VID of the VLAN used for management.
The Transport protocol should always be set to UDP.
The following sections outline how to change the settings for each of the
management options.