Telnet management – PLANET XGS3-42000R User Manual
Page 20
20
9. Telnet Management
Login to the Telnet configuration interface. Valid login name and password are
required; otherwise the Chassis Switch will reject Telnet access. This is a method
to protect the Chassis Switch from unauthorized access. As a result, when Telnet is
enabled for configuring and managing the Chassis Switch, username and password
for authorized Telnet users must be configured with the following command:
username
Privilege option must exist and just is 15. Assume an authorized user in the Chassis
Switch has a username of “admin”, and password of “admin”, the configuration
procedure should like the following:
XGS3-42000R>
enable
XGS3-42000R# config
XGS3-42000R(config)# username admin privilege 15 password 0 admin
Enter valid login name and password in the Telnet configuration interface, Telnet
user will be able to enter the Chassis Switch’s CLI configuration interface. The
commands used in the Telnet CLI interface after login is the same as that in the
Console interface.
Figure 9-1 Telnet Configuration Interface