Avago Technologies MegaRAID SAS 9341-4i - Manual (Page 64)

Avago Technologies
- 64 -
MegaRAID SAS Device Driver Installation User Guide
June 2015 XenServer Driver Installation
Installing or Updating the XenServer 6.2 or 6.5 Operating System Driver
20. For Xenserver 5.6 FP1 installations only, perform the following steps:
Towards the end of the installation process, the installer prompts you for any additional packages. The
megaraid_sas driver RPM listed is listed as a selection.
a. Before you select the megaraid_sas driver RPM, insert the pen drive into the USB slot, and then select Accept
and continue as normal.
b. After the installation completes, select Reboot.
The system now runs under the Citrix® Xenserver OS.
9.3 Installing or Updating the XenServer 6.2 or 6.5 Operating System Driver
Perform the following steps to install or update to the latest version of the MegaRAID SAS driver:
1. Boot the system.
2. Go to Console (your terminal GUI).
3. Install the Dynamic Kernel Module Support (DKMS) driver RPM.
Uninstall the earlier version first, if needed.
4. Install the MegaRAID SAS driver RPM.
Uninstall the earlier version first, if needed.
5. Reboot the system to load the driver.