Avago Technologies MegaRAID SAS 9341-4i - Manual (Page 61)

Avago Technologies
- 61 -
MegaRAID SAS Device Driver Installation User Guide
June 2015 Solaris Driver Installation
Notes
2. Check to see which MegaRAID driver package is installed on your system by using the following command:
— # modinfo | grep mr_sas
To find the inbox MegaRAID SAS package name, run the following commands:
— #pkg list | grep mr_sas
— driver/storage/mr_sas ----> inbox mr_sas IPS packagename
3. If an inbox IPS package is installed, rename the inbox driver files using the following commands.
For x86 systems:
#mv kernel/drv/mr_sas /kernel/drv/mr_sas.inbox
#mv /kernel/drv/amd64/mr_sas /kernel/drv/amd64/mr_sas.inbox
#mv /kernel/drv/mr_sas.conf /kernel/drv/mr_sas.conf.inbox
For SPARC systems:
#mv /kernel/drv/sparcv9/mr_sas /kernel/drv/sparcv9/mr_sas.inbox
#mv /kernel/drv/mr_sas.conf /kernel/drv/mr_sas.conf.inbox
4. Continue with the instructions in Section 8.7, Installing or Upgrading the Driver Package after Operating System
Installation , to complete the installation of the Avago driver package.
8.9 Notes
The following are known limitations:
 The mr_sas driver is not loaded (attached) in the Solaris 10 Update 4 version when you use certain controllers.
This issue is an OS limitation. This issue is fixed in Solaris 10-Update 5 and later.
 In the Solaris 11 OS, the action Install Time Update (ITU) of the driver is not supported. T
he Solaris 11 OS requires IPS packaging; it does not support the legacy Solaris 10 OS ITU install method.