Avago Technologies MegaRAID SAS 9286CV-8eCC - Manual (Page 16)

LSI Corporation
- 16 -
MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
June 2012 MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
4.2.7 Installing the Remote Mount Board in the System
Follow these steps to install the remote mount board in the system.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Insert the remote mounting board in a PCI-Express slot on the motherboard, as shown in the following figure.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Use the bracket screw to secure the remote mount board to the computer chassis.
Figure 10 Installing the Remote Mount Board in the System
5. Reinstall the computer cover, and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information about running the RAID configuration utility and
installing the software drivers.
NOTE Some PCI-Express slots support only PCI-Express graphics cards. If a RAID controller is installed in
one of these slots, the controller does not function. Refer to your computer documentation for
information about the PCI-Express slot.
3_00926-00
Bracket
Screw
Press
Here
Press
Here