Avago Technologies MegaRAID SAS 9286CV-8eCC - Manual (Page 14)

LSI Corporation
- 14 -
MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
June 2012 MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
4.2.5 Connecting the CVFM03 Module on the RAID Controller to the Remote CVPM02 Module on the Remote Mount
Board
Follow these steps to connect the CVFM03 module on the MegaRAID SAS 9286CV-8eCC RAID controller by cable to
the remote CVPM02 module on the remote mount board.
1. Place the controller on a flat, clean, static-free surface.
2. Ground yourself, and make sure that the system is grounded.
3. Remove the cable included in the RAID controller box.
4. Insert the smaller cable connector on the cable into the J2A1 cable connector on the CVFM03 module, as shown
in the following figure.
5. Insert the larger cable connector on the cable into the cable connector that comes out of the remote
CVPM02 module.
Align the cable connectors to make sure they are connected correctly.
Figure 8 Connecting the CVFM03 Module on the RAID Controller to the CVPM02 Module on the Remote Mount Board
NOTE You can insert the cable connector on the remote CVPM02 unit into the larger 6-pin connector on
the cable connector if the latch on one cable connector aligns with the slot on the other cable connector.
The cable end inserts into the connector with minimal resistance.
3_00924-00
CacheVault
Power Module 02
(CVFM02)
J2A1