Avago Technologies MegaRAID SAS 9286CV-8eCC - Manual (Page 10)

LSI Corporation
- 10 -
MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
June 2012 MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
4.2 Attaching the CVFM03 Module to the RAID Controller and Connecting to the Remote
CVPM02 CacheVault Power Module
Perform the tasks described in this section to install the CVFM03 module directly on the MegaRAID SAS 9286CV-8eCC
RAID Controller , connect the CVFM03 module to a CVPM02 module on a remote mount board, and install the RAID
controller and the remote mount board.
4.2.1 Removing the RAID Controller from the Computer
Follow these steps to remove the RAID controller from the computer.
1. Turn off the power, and unplug the power cords.
2. Ground yourself, and make sure that the system is grounded.
3. Remove the cover from the computer, according to the instructions in the system user’s manual, to allow access
to the controller.
4. Unplug all cables from the controller, remove the screw that attaches the bracket to the computer chassis, and
carefully remove the controller from the slot.
5. Place the controller on a flat, clean, static-free surface, and continue with the next procedure.
4.2.2 Installing the CVFM03 Module Directly on the RAID Controller
Follow these steps to install the CVFM03 module on the front of the RAID controller.
1. Ground yourself, and make sure that the system is grounded.
2. Remove the CVFM03 module from the package.
3. Place the CVFM03 module front-side-up on a flat, clean, static-free surface.
4. Place the RAID controller on a flat, clean, static-free surface.
5. Hold the CVFM03 module so that the top side is facing up.
6. Align the J2M1 connector on the CVFM03 module with the J5B1 BBU connector on the RAID controller, as shown
in the following figure.
CAUTION Electrostatic discharge (ESD) can damage the CVFM03 module and the MegaRAID SAS
9286CV-8eCC RAID controller. Make sure that you install the CVFM03 module at an ESD-safe workstation that
meets the EIA-625 specification. When you install the CVFM03 module, follow the ESD-recommended
practices in the latest revision of the IPC-A-610 specification.