Avago Technologies MegaRAID SAS 9286CV-8eCC - Manual (Page 15)

LSI Corporation
- 15 -
MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
June 2012 MegaRAID SAS 9286CV-8eCC RAID Controller Quick Installation Guide
4.2.6 Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on the motherboard.
1. Mount the CVPM02 module to the chassis of your computer, based on the location and the type of
mounting option.
2. With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
3. Install the RAID controller in a PCI-Express slot on the motherboard, as shown in the following figure.
4. Press down gently, but firmly, to seat the card correctly in the slot.
5. Secure the controller to the computer chassis with the bracket screw.
Figure 9 Reinstalling the RAID Controller on the Motherboard
NOTE Because server and workstation chassis vary by vendor, no standard mounting option for the
CVPM02 module is compatible with the various system configurations. Authorized resellers and chassis
manufacturers can customize the location of the super-capacitor pack to provide the most flexibility
within various environments.
NOTE Some PCI-Express slots support only PCI-Express graphics cards. If a RAID controller is installed in
one of these slots, the controller does not function. Refer to your computer documentation for
information about the PCI-Express slot.
Edge of
Motherboard
PCI Express
3_00925-00
Bracket
Screw
Press
Here
Press
Here