Avago Technologies MegaRAID SAS 9240-4i - Manual (Page 35)

LSI Corporation
- 35 -
6Gb/s MegaRAID SAS RAID Controllers User Guide
August 2013
MegaRAID SAS RAID Controller Characteristics
6Gb/s MegaRAID SAS RAID Controller Family
3.1.2.3 MegaRAID SAS 9260CV-4i and MegaRAID SAS 9260CV-8i RAID Controllers – Board Layout and
Jumper/Connector Information
This subsection provides the board layout, and connector and jumper information for the RAID controller. The
following figure shows the location of the jumpers and the connectors on the MegaRAID SAS 9260CV-8i RAID
controller. The jumpers are set at the factory, and you usually do not need to change them.
NOTE The MegaRAID SAS 9260CV-4i RAID controller does not contain the
JT2B1 connector, which supports ports 4 to 7. The JT2B1 connector is
on the MegaRAID SAS 9260CV-8i RAID controller.
Figure 12 Card Layout for the MegaRAID SAS 9260CV-8i RAID Controller
NOTE Pin 1 on the headers and connectors is highlighted in red in this figure.
J4B2 x4 SAS Ports 12 to 15 Internal connector SFF-8087 x4 internal mini SAS connector
Connects the controller by cable to SAS drives or
SATA 2 drives.
J5A2 Write-Pending LED header 2-pin connector
Connects to an LED that indicates when the data in the
cache has yet to be written to the storage devices. Used
when the write-back feature is enabled.
J5B3 Universal Asynchronous Receiver/Transmitter (UART)
debugging 4-pin connector
Reserved for LSI use.
Table 5 MegaRAID SAS 9260-16i RAID Controller – Connectors (Continued)
Jumper/
Connector
Type Description
J5A2
a k
+ve -ve
85081-00
JT1A1
JT1A2
JT1A3
Ports 3-0 Ports 7-4
JT1A4
JT1B1
JT2B1 JT2B2
JT1B2
JT6A1
JT6A2
JT6A3
J5A1