KEPCO TMA 4882-27 - Manual (Page 24)

2-6
TMA 4882-27 021910
2.2.5 FINAL SYSTEM INTERCONNECTIONS
1. Connect the TMA 4882-27 to the GPIB and/or RS 232-C bus.
2. Connect all the power modules to the Control Bus.
3. Connect all power module outputs to their respective loads.
4. Connect source power to TMA 4882-27 and all power modules.
2.3 REAR TERMINATIONS ON THE TMA 4882-27 (SEE FIGURE 2-2)
a. AC Input (J5). The TMA 4882-27 can be powered from an ac source within the range of 95 to
264V. A fuse tray to the left of J5 contains a 2.5A fuse, F1 (SAN-O Corp. P/N MT4 2.5A,
Kepco P/N 141-0087). A spare fuse is stored on the inside of the fuse tray cover.
b. The IEEE 488 BUS (J4). This port is terminated with a 24 pin IEEE 488 connector and con-
forms mechanically and electrically to the IEEE 488 standard. Refer to Table 2-4 for pin
assignments. (NOTE: Removal of the IEEE 488 cable while the unit is operating can be inter-
preted as a GTL (Go To Local) command (see PAR. 2.2.4).
c. The RS 232-C Port (J3). This port is a standard 9 pin RS 232-C (male) connector. Refer to
Table 2-4 for pin assignments and PAR. 2.2.1.4 for additional information.
d. Control Bus Interface (J2). This port is a 9 pin D-type female receptacle. Refer to Table 2-4
for pin assignments.
e. Auxiliary Signals Connector (J1). This port is a 15 pin D-type female receptacle. Refer to
Table 2-4 for pin assignments.