KEPCO TMA 4882-27 - Manual (Page 17)

TMA4882-27 SVC 021910
1-5/1-6
1.4 ACCESSORIES
Table 1-2 lists the accessories provided with the TMA 4882-27 Controller. In configurations
where power modules are daisy chained on the IEEE 1118 control bus (see Figure 1-4), the last
power module control bus outlet (in the daisy chain) must be terminated with one of the IEEE
Control Bus Terminator supplied with the controller to reduce spurious noise and provide proper
impedance matching. Two terminators are supplied, one with a D-type connector, and one with
a round connector for use with Kepco MAT Power Supplies.
TABLE 1-2. ACCESSORIES
ITEM PART NO.
QUANTITY
SUPPLIED
Auxiliary Signals D-type 15 pin mating connector Kepco - 142-0276
(Amp 205206-1)
1
Hood for Auxiliary signals mating connector Kepco - 108-0204
(Amphenol 17-1588-6)
1
Cable, BIT bus with one 5-pin and one 9-pin con-
nector, Daisy chain TMA 4882-27and Kepco Power
Supplies with 5-pin connector on IEEE 1118 bus. Kepco - 118-0749 ~6 ft. (2 m) 1
Kepco 118-0852 ~12 ft. (4 m) (Not Supplied
Terminator, IEEE1118 Control Bus, 9-pin D type Kepco - 195-0086 1
Terminator, IEEE1118 Control Bus, round Kepco - 195-0075 1
Chassis Slide (2 required) Jonathan Series 375 QD (Not supplied)
Cable, BIT bus with two 9-pin DSUB connectors,
daisy chain TMA 4882-27and Kepco Power Sup-
plies with 9-pin connector on IEEE 1118 bus.) Kepco - 118-0844 ~ 6 ft. (2 m)
(Not supplied)
Kepco 118-0853 ~ 12 ft. (4 m)
Connector, Status Monitor Reset (see PAR 3.2.2.)
15 pin, D type
Kepco 195-0088 (Not supplied)
Cable, BIT bus - two 5-pin connectors, daisy chain
Kepco Power Supplies with 5-pin connectors on
IEEE 1118 bus.
Kepco 118-0699 (Not supplied)