KEPCO HSM Series - Manual (Page 13)

HSMSERIES OPR 052912
2-1
SECTION 2 - INSTALLATION
2.1 UNPACKING AND INSPECTION
This instrument has been thoroughly inspected and tested prior to packing and is ready for
operation. After careful unpacking, inspect for shipping damage before attempting to operate.
Perform the preliminary operational check as outlined in PAR. 2.5. If any indication of damage
is found, file an immediate claim with the responsible transport service.
2.2 TERMINATIONS AND CONTROLS
a) Output and Configuration Controls: Refer to Figure 2-1 and Table 2-1.
b) Rear Panel: Refer to Figure 2-2 and Table 2-2.
FIGURE 2-1. HSM SERIES OUTPUT CONTROLS AND CONFIGURATION SWITCH FUNCTIONS
TABLE 2-1. CONFIGURATION CONTROLS
SW
POSITION
FUNCTION REF. PAR.
S1-1 REMOTE LOCKOUT RESET 3.12
S1-2 CURRENT WALK-IN 3.10
S1-3 UNDERVOLTAGE LOCKOUT 3.9
S2-1 RANGE SELECT (VOLTAGE LOOP) 3.4
S2-2 RANGE SELECT (FAULT DETECTOR) 3.4
S2-3 EXT. VOLT. PROG. (VOLTAGE LOOP) 3.3
S2-4 EXT. RES. PROG. (VOLTAGE LOOP) 3.3
S2-5 INT. PROG. (VOLTAGE LOOP) 3.3
S3-1 RANGE SELECT (CURRENT LOOP) 3.6
S3-2 EXT. VOLT. PROG. (CURRENT LOOP) 3.5
S3-3 INT. PROG. (CURRENT LOOP) 3.5