KEPCO BHK-MG VISA Driver Manual (Both Full and 1/2 Rack) - Manual (Page 14)

14
BHK-MG-VISA 010906
2.2.10.9.5 By using combinations of the four basic waveform types, complex waveforms can be generated,
and repeated using the Pattern Execution window (see PAR. 2.2.11) to provide great flexibility in determin-
ing the output.
2.2.11 The Pattern Execution window (Figure 14) allows the program established by the pattern genera-
tion window to be executed. If the Loop Direction is set to UP, the Loop From window establishes the
point in the loop that will start repeating. For example, if the list is 10 points, and Loop From is set to 3, the
first 2 points would only be executed once, and the points from 3 to 10 would be repeated the number of
times specified in the Loop Count Window. If Loop Count is set to 0 the program will run continuously until
stopped by the user. The RUN button starts the program. While the program is running the Running indi-
cator is on and the RUN button changes to a STOP button used to halt the program. When the program is
halted, the unit reverts to the settings in effect prior to issuing the RUN command.
FIGURE 14. PATTERN EXECUTION WINDOW
2.2.12 The Front Panel button allows the front panel keyboard to be locked during remote operation.
2.2.13 The Utilities button opens the Utilities window (Figure 15). The Calibration Data Dump button
allows calibration data in hex format to be sent to the host computer via the GPIB. If the correct password
is entered, the calibration Data Restore button allows the unit to accept previously dumped calibration
data and replace the Factory, Working, or Prior calibration.
2.2.14 The Hardware Test button tests the validity of system parameters (e.g., CRC).
FIGURE 15. UTILITIES WINDOW
The Display Open button opens the Display Change window (Figure 16) which permits adjustment of con-
trast display.
FIGURE 16. DISPLAY CHANGE WINDOW