beautypg.com

Network (tcp/ip) settings -3 – TA Triumph-Adler DC 2116 User Manual

Page 15

background image

Set-up

2-3

Network (TCP/IP) settings

This section explains the procedures to set the network address for the scanner.

Notes

The network address that should be set here will differ depending upon your network
environment. Check with your network administrator BEFORE performing this setting.

If you are using a DHCP server to set the network addresses, you will not need to change the
IP address and the subnet mask because the DHCP has been enabled (ON) as the factory
default setting.

1

Press the System Menu/Counter key to display the
Default setting screen.

2

Use the

S and T keys to move

D

to select

Scan

default and then press the Enter key. The password
entry screen will appear.

3

Enter the password with Numeric keys. The password
at the factory default setting is 1600 for the 16 ppm
model, 2000 for the 20 ppm model and 2500 for the 25
ppm model.

Notes

If the password matches, the screen will change to the

Scanner setting screen.

Four-digit password can be changed. Refer to the Operetion Guide of machine.

4

Use the S and T keys to move

D

to select DHCP and

then press the Enter key. Screen will change to the
DHCP/BOOTP setting screen.

5

Use the S and T keys to move

D

to select 1 Off

and then press the Enter key. Screen will return to the
Scanner setting screen of Step 4.

Note

If you are using a DHCP server, select

2 On. In this case, even if you enter each IP address and

subnet mask manually, the entered settings will be ignored.

6

Use the S and T keys to move

D

to select IP

address and then press the Enter key. Screen will

change to the IP address setting screen.

7

Enter the IP address by every three digits with Numeric
keys. Press > key to move to the following three digits.
Check the entered IP address and then press the
Enter key if it is correct. Screen will return to the
Scanner setting screen of Step 6.

Copy default

Machine default

Default setting / Counter

Scan default

Enter Pin Code using # key.

Subnet

Scan Default:

Gateway

DHCP/BOOTP

255.255.255. 0

10.

On

181. 12.11

:

:

:

Off

On

DHCP/BOOTP

>

IP Address

Subnet

Scan Default:

Gateway

10. 181. 15. 11

255. 255.255. 0

:

:

: 10. 181. 12. 11

IP Address

10

15

.

.

11

181 .

This manual is related to the following products: