TA Triumph-Adler DC 2025 - Manual (Page 46)

2-5
Section 2 Fax Operation (Various Functions)
1
6
(Inch)
(Metric)
Interrupt Transmission
Interrupt Transmission lets you send your documents before others, eliminating the need to wait until all communications are complete
whenever the fax is currently scheduled for multiple communications (Broadcast Transmission or Polling Reception, etc.), or there are other
communications already scheduled in memory ahead of yours.
* Interrupt Transmission may only be accomplished to a single destination.
* A maximum of 50 communications (including any combination of Interrupt Transmissions, communications that use the timer and Standby
Transmissions) can be scheduled at one time.
* Depending on the timing of when you perform the Interrupt Transmission procedure, there are occasions where your documents may not be
send “immediately” after the current communication.
* If you want to cancel an Interrupt Transmission, simply remove the set documents.
* To cancel an Interrupt Transmission while it is still waiting to start, perform the same procedure as in “
● Canceling a waiting transmission in
the Direct Feed Transmission mode...” on page 2-3.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Touch the “Memory TX” key until it changes to “Dir. Feed Tx”.
2. Set the documents you want to transmit in the Document
Processor or on the platen.
* When the documents are set on the platen, it is necessary, after
each page is scanned, to select whether or not you want to
transmit more pages and to select the size of each page.
(Refer to page 1-18.)
3. Enter the destination fax number.
* You can enter the fax number using the keypad, abbreviated
numbers, one-touch keys or the directory. Chain dial keys can be
used as well.
4. Press the Start key. The documents will remain in the Document
Processor or on the platen, without being scanned, waiting for the
transmitting
operation to begin.
Once the operation currently in progress is completed, the
transmission operation for your documents will begin automatically.