TA Triumph-Adler DC 2025 - Manual (Page 113)

Section 6 Various Settings and Registration
6-1
(Inch)
(Metric)
(Inch)
(Metric)
Section 6 Various Settings and Registration
Turning Report Print Out ON/OFF
Five different reports can be printed out for checking such points as
whether a transmission or reception was accomplished correctly or
not. You can also have each of these reports printed out
automatically or turn OFF automatic print out of each report.
Set this report to be printed out upon reaching a predetermined
number of communications in order to check the details of those
communications.
Set this report to be printed out after each transmission to check
whether the transmission was accomplished correctly or not.
* Select “Output on condition” and then, it is possible to set
this report to be printed out only under certain condition
such as a communication error, a Broadcast Transmission,
and a transmission that uses the timer .
.
Set this report to be printed out after each reception to check
whether the reception was accomplished correctly or not.
* Select “Output on condition” and then, it is possible to set
this report to be printed out only under certain condition
such as a communication error, a Polling Reception, an
Encryption Reception and an F-Code Based Confidential
Reception.
Set this report to be printed out after each communication that
uses the timer is scheduled to check the information related to
that communication.
Set this report to be printed out whenever Restricted Access is
turned ON in order to check the details, listed by department, of
all communications occurring under Restricted Access.
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the initial mode settings.
1. Press the Default key. The Default Setting screen will appear.
2. Touch the “Fax default” key.
3. Touch the “ ▼” cursor key until “Print Report” is highlighted.
4. Touch the “Change #” key.
When the optional Printer/Scanner Kit is installed on this fax
machine, you can have this report attached to an e-mail mes-
sage in order to check whether each Network FAX transmission
was accomplished correctly or not.
* Select “Output on condition” and then, it is possible to set
this report to be printed out only under certain condition
such as a communication error, a Broadcast Transmission,
and a transmission that uses the timer.