TA Triumph-Adler DC 2016 - Manual (Page 67)

Section 6 COPIER MANAGEMENT
6-11
Default Settings Mode Operations
Procedures
Follow the procedure listed below to operate in the [Default
Settings Mode].
1
Depress the [Exposure Adjustment] keys on both sides for 3
seconds. “F00 (Default Settings Mode)” will be displayed in
the No. of Copies display.
2
Press either the Zoom (+) key or the Zoom (–) key and select
each Default Settings Mode.
Inch
specifications Metric specifications
Notes
• Each of the Default Setting Modes can be selected by
pressing the Keypad keys.
• Refer to "Procedure for Changing the Default
Settings" regarding the following.
3
After completing each operation, press on the Zoom (+) or
Zoom (–) key to display “F00”.
Inch
specifications Metric specifications
4
Press the [OK] key. The mode display will return to the No.
of Copies display.
Inch specifications
Metric specifications
Procedure for Changing the Default
Settings
The procedure for changing each of the items in the Default
Settings is described below.
User Status Report
Outputs a list of the values set for the Default Settings items.
Note
Check to make sure that 11" × 8 1/2 "/A4 size paper is
loaded in the drawer.
1
Display the Default Settings Mode. (Refer to P.6-11
"Default Settings Mode Operations Procedures".)
Inch specifications
Metric specifications
2
Press either the Zoom (+) or Zoom (–) key to display “F01”.
Inch specifications
Metric specifications