TA Triumph-Adler LP 4140 - Manual (Page 67)

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-39
7 The following example explains how to
activate TCP/IP protocol to connect the
printer in the network. You can select
Netware or AppleTalk in a similar manner.
If TCP/IP is currently displays Off, select
On
using U or V. Press [OK] again.
8 Press
Z. Each time U or V is pressed, the item changes as shown below.
9 Display the item to be set and press [OK].
For DHCP or BOOTP, a question mark (?) appears. For IP Address,
Subnet Mask, and Gateway, the cursor (_) blinks.
10 For DHCP or BOOTP, select On or Off using
U or V. For IP Address,
Subnet Mask, and Gateway addresses, press U or V to change the
number (000 to 255) where the cursor is blinking. You can use Z and Y to
move the cursor right and left.
11 To obtain these addresses, consult your network administrator.
>TCP/IP >
On
>TCP/IP
? Off
>TCP/IP >
On
>>DHCP
Off
>>BOOTP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000