TA Triumph-Adler LP 4140 - Manual (Page 124)

Using the Operation Panel
2-96 ADVANCED OPERATION GUIDE
Staple Error Detection Setting
This setting controls whether or not message Add staples Press GO
appears when the finisher units runs out of staples during output of a
stabled job.
1 Press [MENU].
2 Press U or V repeatedly until Others >
appears.
3 Press Z.
4 Press U or V repeatedly until >
Finishing Error > appears.
5 Press Z.
6 Press U or V repeatedly until >>Staple
appears.
7 Press [OK]. A blinking question mark (?)
appears.
8 Press
U or V to change Off to On.
9 Press [OK].
10 To exit the menu selection, press [MENU].
On
Message is displayed and printing pauses.
Printing resumes automatically when staples are
replenished. When pressing [GO], the printer
continues printing without stapling.
Off
Add Staples is displayed, but printing continues
without stapling.
Others >
>Finishing >
Error
>>Staple
Off
>>Staple
? Off