TA Triumph-Adler LP 4140 - Manual (Page 125)

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-97
Punch Error Detection Setting
This setting is possible only when the Punch Unit is installed on the
optional finisher unit. This setting controls whether or not the message
Check chad box Press GO
appears when the chad box on the punch
unit becomes full.
1 Press [MENU].
2 Press U or V repeatedly until Others >
appears.
3 Press Z.
4 Press U or V repeatedly until
>Finishing Error > appears.
5 Press Z.
6 Press U or V repeatedly until >>Punch
appears.
7 Press [OK]. A blinking question mark (?)
appears.
8 Press
U or V to change Off to On.
9 Press [OK].
10 To exit the menu selection, press [MENU].
On
Message is displayed and printing pauses.
Printing resumes automatically when the chad box is
emptied and replaced back into the punch unit.
Off
Chad box full is displayed, but printing continues
without punching.
Others >
>Finishing >
Error
>>Punch
Off
>>Punch
? Off