beautypg.com

Rose Electronics Porter User Manual

Page 32

background image

28

PORTER INSTALLATION AND OPERATIONS MANUAL

Test 3 – Static ram read/write test

This test is the same as in the ‘Short Test’
Test 4 – Non-volatile RAM checksum test

This test is the same as in the ‘Short Test’
Test 5 – Port addressing test

This test ensures that the contents of non-volatile memory agree with the port

configuration. If this test fails (see Table VI) then the configuration memory has been

corrupted or a port communication chip has failed. Reload the factory default settings as

described below and retry the test. Make sure there are no cables connected to the

Porter. Re-run the test, if the test still fails then the unit must be serviced. The ADVANCE

switch may be pressed to determine which port is the failing port. BUF, DATA, and BUSY

LEDs will all be lit. The LEDs of all ports which pass will be it. A failing port will have its

corresponding LED off. The SELECT switch may be pressed to execute the test again. In

order to bypass this test completely, both the ADVANCE and SELECT switches may be

pressed.
Test 6 – Module test without loopback

This test ensures that there are no signal shorts on a port. In order for this test to pass,

no equipment should be connected to the Porter. If this test fails (see TABLE VI) then a

port communication chip has failed and the unit must be serviced. The ADVANCE switch

may be pressed to determine which port is the failing port. BUF, DATA, and BUSY will all

be flashing. The LEDs of all ports which pass will be flashing. A failing port will have its

corresponding LED steadily lit. Ports not installed will have their corresponding LEDs off.

This test will continuously execute until all ports pass or the test is bypassed. In order to

bypass this test completely, both the ADVANCE and SELECT switches may be pressed.

Table V Diagnostics LED Display

Legend: M=Mode LED D=Data LED B=Busy LED E=Error LED

= LED off

= LED on

M D B E

1

2

3

4

5

6 7

8

1st

All LEDS on

2nd

Test 1: EPROM checked

3rd

Test 2: 16K RAM buffer

Test 2: 64k RAM buffer

Test 2: 256k RAM buffer

4th

Test 3: Static ram

5th

Test 4: Non-Volatile ram

6th

Test 5: Port type test

7

th

Test 6: Module test