Remote Processing CX-10 User Manual
Page 9
SETUP AND OPERATION - MODBUS and BASIC
SECTION 2
Page 2-4
Figure 2-3 Communications Setup
Next step is to set the communication port to match your
PC. See “Communication Setup” above to help
determine what ports you have available if you do not
know.
Click on the “System Setup” tab at the top of the
program screen. You should get a screen similar to
below.
Select the Com port that is connected to the RS-232
modbus port.
Make sure the Baud Rate is set to 19200.
All other parameters under “Serial Port Setup” should
not have to be changed.