Precision Digital PD6200 - Manual (Page 86)

Model PD6200 Analog Input Rate/Totalizer Instruction Manual
86
Meter Copy or Cloning Instructions
!
Caution!
Do not connect the two meters to
the same signal source while
cloning. Internal calibration may
be affected.
1. Connect two meters using a PDA1200 meter copy cable.
Warning!
Use PDA1200 meter copy cable only!
Using standard CAT5 or other cable will cause
damage to both meters.
2. Do not connect the two meters to the same signal source.
3. Power up both meters. Leave Clone meter in Run Mode.
4. Enter
the Advanced Features menu of the Master meter see Ad-
vanced Features Menu page 71.
5. Scroll to the Copy function using the Up arrow button then press
Enter.
6. The meter displays the message Send. Press Enter, the display
flashes while sending data. The message done is displayed when
copying is completed.
Send
Copy
done
Copy
Display flashes
while sending
data
Copy
7. The Clone meter displays the message CPY rC while being pro-
grammed then the message done when copying is completed. The
meter initializes and returns to Run Mode using the same settings
as the Master.
8. If meter to be cloned does not respond to the data being sent, refer
to Copy Function Requirements above.