MEDC Weatherproof FernTel IP - Manual (Page 9)

Short manual FernTel IP / IP150 Page 9
Top view with
disconnected keypad
Top view Bottom view keypad
*depending on version
Figure 5: Set View
Plug the ribbon cable onto the pin contact strip (7) of the keypad plate.
Tighten the keypad plate (6) using four screws (8).
The fixing screws (8) are provided with sealing plugs (10). A bag of sealing plugs
(10) is included in the device.
1.3.2 Table Version
Place the telephone in the lower latches (A), swing it backwards until the upper
latches audibly engage (B).