Ericsson R250d PRO - Manual (Page 61)

Not for commercial use
– Ericsson Inc.
0HQX 'HVFULSWLRQV
Receiving
You can allow or restrict incoming phone calls. If
selected, the terminal does not ring during incoming
calls.
Sec. Code
You can change your four-digit security code. The fac-
tory-set code is 0000. You are prompted to repeat the
code for verification.
Call Cards Menu
The CALL CARDS Menu contains the following
choices for storing two calling card numbers to use for
making long distance phone calls in Phone Mode.
Note! You must enter your security code before you can open
the CALL CARDS Menu.
Card Select
You can store two calling card numbers. You select
which number your terminal uses through the CALL
CARDS Menu.
Press Ô
to enter Menu Mode.
Press Ñ
or
Ô
until the menu pointer is beside
Call Cards.
Press <(6 to open the CALL CARDS Menu.
Press Ñ
or
Ô
until the menu pointer is beside
CardSelect.
Press <(6 .
Press Ñ
or
Ô
until the card you want to use
(Card One or Card Two) is enclosed in
brackets.
Press <(6 to store your selection.
Card1 and Card2 Setup
Calling Card Setup
Make sure you have the following:
• Calling Card Access Number (a number provided
by your long distance service provider).
• Verification Number (a number you must enter to
allow the calling card call to be completed).
To set up a calling card, complete the following steps.
Press Ô
to enter Menu Mode.
Press Ñ
or
Ô
until the menu pointer is beside
Call Cards.
Press <(6 to open the CALL CARDS Menu. You
are prompted to enter your security code.
Press Ñ
or
Ô
until the menu pointer is beside
Card1Setup or Card2Setup.
Press <(6 to enter card setup.
Ditto Lornetta.book Page 56 Thursday, July 13, 2000 3:55 PM