Ericsson R250d PRO - Manual (Page 21)

Not for commercial use
– Ericsson Inc.
*HWWLQJ 6WDUWHG
The terminal automatically starts charging the battery
when you attach the charger. The following indicate
charging:
• The battery meter in the display will continuously
fill and empty.
• The indicator on top of the terminal will show a
steady red light (green, if the terminal is turned on).
When the battery is fully charged, the battery meter in
the display shows full and the indicator on top of the
terminal shows a steady green light.
Note! It is possible to use the terminal while the battery is
being charged with the rapid charger or travel charger.
Using the terminal to make or receive calls while the ter-
minal is being charged will increase the charging time.
To disconnect the charger, first lift the plug connected to
the terminal upwards and then pull it out.
Your Charger
Rapid Charger
The rapid charger supplies power
to charge your battery while the
battery is attached to your termi-
nal. You can make and receive calls
while using the rapid charger, if
you wish. To charge your battery
with the rapid charger:
Plug the charger into a stan-
dard wall electrical outlet.
Hold the terminal with the display and keypad up.
Hold the small plug on the charger cord so the light-
ning bolt symbol is up.
Align the small plug on the charger cord with the
connector on the bottom of your terminal. The con-
nector on the terminal is above the lightning bolt
symbol.
Press the plug into the connector until the plug
"snaps" into place.
Ditto Lornetta.book Page 16 Thursday, July 13, 2000 3:55 PM