Epson 5600p - Manual (Page 68)

62 Maintaining and Transporting the Projector
6. Insert the new lamp as shown.
7. Make sure the lamp is fully seated, then tighten its screws.
8. Replace the lamp cover and tighten its screw securely. (The
projector won’t come on if the lamp cover is loose.)
9. Reset the lamp timer as described in the following section.
Resetting the Lamp Timer
After installing a new lamp, you need to reset the timer so the
projector can keep track of how many hours it has been used. Follow
these steps:
1. Plug in the projector and turn it on (see page 22).
2. After the projection lamp comes on, press the Help button and
hold it down for at least 5 seconds.
You see the Help menu, and then the following message:
caution
Do not touch the glass
portion of the lamp assembly.
Touching the glass could
result in premature lamp
failure.
Reset Lamp ON Time
Do you reset the Lamp ON Time?
Yes No
:Select :Execute
5600 and 7600.book Page 62 Thursday, December 14, 2000 2:46 PM