Epson 5600p - Manual (Page 92)

86 Connecting to Additional Equipment
Connecting to a Second Computer
To connect a second computer to the projector, you need to use the
projector’s
Computer 2/Component Video port. You’ll also need an
additional VGA (D-sub 15-pin) cable, like the one that came with
your projector. You can purchase this from your computer or
electronics dealer.
Follow these steps:
1. Connect one end of the cable to the computer’s video port.
2. Connect the other end to the projector’s Computer 2/
Component Video port as shown.
3. To display images properly, make sure the BNC option in the
projector’s Setting menu is set to RGB . See page 54 for
instructions.
4. If you want to hear the computer’s audio through the projector,
you’ll need an RCA-to-3.5 mm stereo cable (available for
purchase from your electronics store or video dealer).
Insert the cable’s 3.5-mm plug into your computer’s audio-out
port. Then attach the connectors at the other end of the cable to
the projector’s
Audio 2 jacks, matching the white plug to the L
jack and the red plug to the R jack.
Computer 2 /
Component Video
Computer 1
Analog Digital
Audio 1 Audio Out
Control (RS-232C) Mouse
S-Video
L-Audio2-R Video
Remote
Computer 2/
Component Video
port
Audio 2 jacks
5600 and 7600.book Page 86 Thursday, December 14, 2000 2:46 PM