Pressure Systems 9022 User Manual

Page 86

Pressure Systems, Inc.

NetScanner™ System (9016, 9021, & 9022) User’s Manual

www.PressureSystems.com

3 - 56

Bit 6: SRAM Error.

reserved

Number of A/D Samples To Average, as hex value (e.g., 000A=10 decimal).

IP Address Resolution Method, as hex state: (default = 0000)

0000 = Use Static IP Address stored in module’s non-volatile memory
0001 = Get Dynamic IP Address from external RARP/BOOTP server

Host Response/Stream Back-Off Delay, as hex value (or FFFF). FFFF
means use low-order byte of module’s Ethernet Address as value instead. In
either case, back-off delay in microseconds is calculated from decimal
equivalent of hex value:

delay = decvalue * 20

Host Response/Stream Total Size Prefix (with 2-byte big-endian binary
value), added to all command responses and streams to indicate their true
length in bytes:

0000 = None (default)
0001 = Yes

TCP Connect Port, as hex value (e.g. 2328 = 9000 decimal, default).

Auto UDP Broadcast@Reset, as hex state:

0000 = No (default)
0001 = Yes

Temperature Status of Each Scanner Transducer (9016 only), as 16-bit hex
bit map, each bit representing the current status of a transducer/channel (16-1)).
Bit values are:

0= transducer operating within the specified operational limits.
1= transducer operating outside the specified limits.

(see end-of-table NOTE +)

Minimum Temperature Alarm Set Point (9016 only)(in degrees C), as
decimal (**) format 0 representation of internal IEEE float, with leading
space).

Maximum Temperature Alarm Set Point (9016 only)(in degrees C), as
decimal (**) format 0 representation of internal IEEE float, with leading
space).