Epson AcuLaser C9200 Series - Manual (Page 94)

USB Menu
Item Settings (default in bold)
USB I/F *1 On, Off
USB Speed *1 *2 HS, FS
Get IP Address *2 *3 Auto, PING, Panel
IP *2 *3 *4 *5 0.0.0.1 to 255.255.255.254
SM *2 *3 0.0.0.0 to 255.255.255.255
GW *2 *3 0.0.0.0 to 255.255.255.255
NetWare *2 *3 On, Off
AppleTalk *2 *3 On, Off
MS Network *2 *3 On, Off
Bonjour *2 *3 On, Off
USB Ext I/F Init *2 *3 -
Buffer Size *1 *2 Normal, Maximum, Minimum
*1 After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again. While
it is reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power
is turned on again.
*2 Available only whenUSB I/F is set to On.
*3 Available only when a USB external device with D4 support is connected. The contents of the settings depend on the
USB external device settings.
*4 If theGet IPAddress setting is set to Auto, this setting cannot be changed.
*5 When theGet IPAddress setting is changed from Panel or PING to Auto, the panel setting values are saved. Then Auto
is changed back to Panel or PING, the saved setting values are displayed. The value is set to 192.168.192.168 if the
settings are not made from the panel.
USB I/F
Allows you to activate or deactivate the USB interface.
USB Speed
Allows you to select the operation mode of USB interface. Selecting HS is recommended. Select FS if
HS
does not work on your computer system.
EPSON AcuLaser C9200 Series User's Guide
Using the Control Panel 94