Silvercrest SKGE 2000 A1 - Manual (Page 11)

SilverCrest EDS SKGE 2000 A1
English - 9
Setting II = Heat up
Setting III = Medium level of grill
Setting MAX = Maximum level of grill
 As soon as the contact grill is connected to the mains socket, the POWER LED (7) lights up and
the contact grill starts to heat up. When the set temperature is reached, the READY LED (8) also
lights up.
 Place the food to be grilled directly on the grill plates (3 and 6). The contact grill heats up
again once the temperature drops below the set level. This is indicated by the READY LED (8)
going out at this time.
 Turn the food from time to time.
 Switch off the contact grill after use by turning the thermostat (9) to "●" and remove the mains
plug from the socket.
 Clean the contact grill as described in the section "Cleaning".
Gratinating
This mode (Figure C) is suitable for gratinating food. Proceed as follows:
 Turn the thermostat (9) to "●".

Set the slider (4) to " " in order to release the cover.
 Open the cover.
 Grease the bottom grill plate (6) if necessary with suitable grease, margarine or oil and close
the cover. Please note that butter is unsuitable due to the high temperatures.
 Insert the mains plug into a mains socket that is always easily accessible.
 Turn the thermostat (9) to the desired setting.
Setting I = Defrost
Setting II = Heat up
Setting III = Medium level of grill
Setting MAX = Maximum level of grill
 As soon as the contact grill is connected to the mains socket, the POWER LED (7) lights up and
the contact grill starts to heat up. When the set temperature is reached, the READY LED (8) also
lights up.
 Now open the cover and place the food to be grilled directly on the bottom grill plate (6). Set
the slider (4) to a suitable position (I, II, III, IV or V) so that the top grill plate (3) does not touch
the food when you close the cover. Then close the cover. The contact grill heats up again once
the temperature drops below the set level. This is indicated by the READY LED (8) going out at
this time.
 Switch off the contact grill after use by turning the thermostat (9) to "●" and remove the mains
plug from the socket.
 Clean the contact grill as described in the section "Cleaning".