Silvercrest SKMP 1200 A2 - Manual (Page 65)

SKMP 1200 A2 63
5. Unlock the mixing bowl 16 by rotating
slightly in a clockwise direction.
6. Remove the mixing bowl 16.
7. Press the unlock lever 6 and swing the
drive arm 1 down into the working
position.
Note: Press the unlock lever 6 round
fully and hold until the drive arm 1 is
right down. Then swing the unlock
lever 6 back again.
Removing the blender jug 12 :
1. Turn the blender jug 12 anti-clockwise
until that the little nib points to the open
padlock symbol.
2. Remove the blender jug 12.
3. Put the lid 2 back on.
6.3 Using the splash guard
You can add ingredients during mixing:
1. Reduce the speed to 1 - 2.
2. Lift the flap over the filling opening 9.
3. Add ingredients.
4. Close the flap over the filling opening 9
again.
6.4 Using the blender jug 12
Caution!
• Never allow the blender to run for more
than 3 minutes at a time. It then has to
cool down again first to prevent the
appliance overheating.
1. Always put the liquid ingredients in the
blender jug first, followed by the solid
components 12.
2. Chop up the solid ingredients
beforehand to stop any lumps jamming
the blades.
3. Make sure you always replace the
lid 11 on the blender jug 12 before
starting the blender as the contents
might otherwise be ejected.
4. If you wish to add other ingredients
during blending, open the fastening 10
in the lid 11 of the blender jug 12 by
turning clockwise.
5. Select the desired speed on the speed
controller 4 .
Note: The ideal speed mainly depends
on the consistency of the food to be
blended. The more liquid it is, the faster
blending can be carried out.
6. Alternatively, you can press the pulse
button 5 here. Blending will take place
at maximum speed as long as the pulse
button 5 is held down.
Note: The pulse button 5 only functions
when at least level 1 is set on the speed
controller 4.
RP100104-105590-Küchenmaschine LB5 Seite 63 Dienstag, 10. Juni 2014 12:00 12