Sealey SA9302 User Manual

Sealey Tools

3.1

INSTALLATION FOR BOTH MODELS

3.1.1

AIR SUPPLY - MAXIMUM PRESSURE 12bar (175psi)

The supply must be clean and dry - use a suitable filter/water trap if necessary. The supply pressure at the gauge

inlet should ideally be 10bar (145psi).

Note: Maximum tyre inflation pressure cannot exceed the supply pressure.

1. SAFETY INSTRUCTIONS

3 Disconnect the gauge from the air supply before changing accessories, servicing or performing any maintenance.

3 Maintain the gauge in good condition (use an authorised service agent), and keep the gauge clean for best and safest

performance.

3 Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate

the warranty.

3 Locate gauge in a suitable work area, keep area clean and tidy and free from unrelated materials and ensure there is

adequate lighting.

3 Keep children and unauthorised persons away from the work area.

7 DO NOT direct gauge outlet at yourself or at other persons or animals.

7 DO NOT carry by the hose, or yank the hose from the air supply.

7 DO NOT use the gauge for a task which it is not designed to perform.

7 DO NOT operate the gauge when you are tired or under the influence of alcohol, drugs or intoxicating medication.

7 DO NOT operate gauge if parts are missing or the gauge is damaged, as this may cause failure and/or

personal injury.

2. INTRODUCTION & SPECIFICATIONS

3. INSTALLATION

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS

PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL

INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS FOR FUTURE USE.

SA9302 & SA9312 - 1 - 091105

INSTRUCTIONS FOR:

PROFESSIONAL AIR LINE GAUGES

MODELS: SA9302 & SA9312

SA9302: Composite body and dial type gauge with rubber protector. Calibrated in bar/psi. Fitted with 500mm rubber hose

and single clip-on connector.

SA9312: Composite body and dial type gauge with rubber protector. Calibrated in bar/psi. Fitted with 500mm rubber hose

and a twin push-on connector.

SPECIFICATION. SA9302

SA9312

Range:

0-10bar (145psi).

Air Supply Maximum:

12bar (175psi).

Inlet:

1/4BSP Male.

Connector:

Single clip.

Twin push on.

Hose:

500mm rubber.

SA9312

SA9302

Clip-on Connector

Twin Push-on Connector

Operating Lever

Gauge

1/4BSP Male

This manual is related to the following products:

SA9312