Maintenance – Sealey RE231 User Manual
Page 4
7.1. Before each use, check the compressor to ensure it is not damaged or worn. If in any doubt DO NOT use the unit. remove it from
service immediately and contact your local sealey dealer for advice/repairs.
7.2. refilling the hydraulic system with oil is rarely necessary but the level should be checked in the event of a loss of performance. to
check oil level, ensure the ram is fully lowered, remove filler plug and check that level is within 10mm of filler hole. Add hydraulic jack oil
if necessary.
NOTE: use a good quality jack oil, such as seAleY HYdrAulIc JAcK oIl.
WARNING: DO NOt use brake fluid, or any fluid other than hydraulic jack oil as this will cause serious damage and will invalidate the
warranty!
6.11. Allow the spring to gradually decompress by carefully operating the valve release pedal keeping your hands and fingers away from the
spring assembly.
6.12. replace the spring or shock absorber as necessary and reassemble the strut by first compressing the spring and then introducing the
shock absorber up through the lower yoke and compressed spring coils. reattach the top plate and top nut.
6.13. Before releasing the compression ensure that the top strut nut is securely fastened to the maker’s tolerance.
6.14. release the compression slowly keeping your hands and fingers away from the spring assembly.
6.15. Be sure that the tension on the spring is fully controlled by the strut assembly before removing it from the yokes of the compressor.
7. MAINTENANCE
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park
,
Bury st. edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
re231.V3, re232.V3 Issue: 1 - 01/09/14
Original Language Version
© Jack sealey limited