Sealey RE229 - Manual (Page 2)

 WARNING! Do not compress the spring to an extent where the coil windings or
jaws touch, (Fig.2.A, Fig.2.B).
 Ensure the jaws and the body of the compressor are correctly aligned and well
spaced at all times during spring compression (Fig.3.A). For conical springs, the
centre line of the spring should remain parallel to the compressor body, (Fig.3.B).
If necessary use the extension block as in Fig.4 to keep the spring and
compressor body parallel.
 Secure the strut with a clamp, vice or other adequate holding device.
3.1. To Compress a Strut Removed From a Vehicle.
3.1.1. Mount the selected jaws on the compressor body, fit the retaining bolts and
tighten securely.
3.1.2. Rotate the hexagonal nut, using air or hand tools to drive the jaws apart to the
length of the spring and to allow compression of as many windings as possible.
3.1.3. Place the spring strut compressor onto the spring, ensuring the spring seats
correctly (Fig.1.B) between the safety lips (Fig.1.6) and the outer rib (Fig.1.7)
and cannot slide out during compression.
3.1.4. Ensure the jaws and body are correctly aligned, (Fig.3 / 4).
3.1.5. Rotate the hexagonal nut, using air or hand tools and compress the spring until
the upper support bearing is free and the spring will rotate.
3.2. To Decompress a Strut Removed From a Vehicle.
3.2.1. To decompress the spring, reverse the compress procedure.
4. MAINTAINING THE COMPRESSOR
A
Fig.2
B
A
B
3. INSTRUCTIONS FOR USE
Fig.3
Fig.4
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version RE229.V2 Issue: 1 - 11/05/12
01284 757500
01284 703534 [email protected]
www.sealey.co.uk
Web
email
4.1. General Maintenance.
4.1.1. Before each use check the compressor to ensure it is not damaged or worn.
If suspect, do not use the unit, but contact your local Sealey Dealer who will be
able to advise you regarding repair kits and spare parts.
4.1.2. Grease the compressor spindle as necessary, at least every six months.
4.1.3. Keep the compressor clean, and when not in use, store in a safe, dry,
childproof location.
Parts support is available for this product. To obtain a parts listing
and/or diagram, please log on to www.sealey.co.uk,
email [email protected] or phone 01284 757500.