Sealey VS7020 User Manual
Wheel bearing removal / installation kit, Instructions for, Model no
WARNING! Ensure all Health and Safety, local authority,
and general workshop practice regulations are strictly
adhered to when using tools.
DO NOT use tools if damaged or worn.
Maintain the tools in good and clean condition for best and
safest performance.
Ensure all threads are clean and well lubricated.
Ensure vehicle is adequately supported with axle stands,
ramps, etc. as appropriate.
Wear suitable clothing to avoid snagging. Do not wear
jewellery. Tie back long hair.
Wear approved eye protection. A full range of personal
safety equipment is available from your Sealey dealer.
Account for all tools and parts being used and do not
leave them in or on the vehicle.
IMPORTANT: Always refer to the vehicle manufacturer’s
service instructions, or proprietary manual, to establish the
correct procedure and data for the specific vehicle you are
working on. These instructions for use are provided as a
guide only.
INSTRUCTIONS FOR:
WHEEL BEARING
REMOVAL / INSTALLATION KIT
MODEL No:
VS7020.V2
2. INTRODucTION
3. SPEcIfIcATIONS
4. INSTRucTIONS
1. SAfETY INSTRucTIONS
1.
HuB ScREW NuT
5.
VEHIcLE HuB
2.
WASHER
6.
SLEEVE
3.
DRIfTS
7.
SLEEVE cAP
4.
BEARING
8.
HuB ScREW
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INfORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole uK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
VS7020.V2 Issue: 1 - 11/05/12
Comprehensive kit of tools for the fast and effective removal and
installation of wheel bearings on front-wheel drive vehicles.
Reduces chances of damage to hub and bearing. Heavy-duty
steel drifts with phosphate coating to prevent corrosion. Heavy-
weight drive screw for use with impact tools. Also suitable for
removing and installing large industrial bearings. Supplied in
carry-case.
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.
Model No:
VS7020.V2
Drift Sizes Ø:
50, 55, 60, 64, 67, 73, 75, 78, 82, 84,
88mm
Sleeve Ø External:
76, 86, 92, 101mm
Hub screw length:
210mm
Hub screw drive:
32, 38mm
BEARING REMOVAL: Identify the correct sleeve (6) to sit on
the outside of the bearing housing and the correct drift (3) to
drive the bearing from the housing. Assemble as shown in fig.1A
using the correct sleeve cap (7). Keep the hub screw and nut
well lubricated whilst driving out the bearing.
BEARING INSTALLATION: Identify the correct sleeve cap (7) to
sit on the outside of the bearing housing and the correct
diameter drift (3) to drive the new bearing into the housing.
Assemble as shown in fig.1B. Keep the hub screw and nut well
lubricated whilst driving the new bearing into the housing.
fig.1