Sealey VS2046 - Manual (Page 2)

fig.1
fig.3
fig.2
Return Pipe
Measurement
Tube or Flexible
Pipe
4. PARTS
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
01284 757500
01284 703534 [email protected]
www.sealey.co.uk
Web
email
Original Language Version
VS2046.V2, VS2047.V2, VS2048.V2 Issue: 2 (SP) -28/02/13
Part Part No. Description
1 VS2048.V2-01 Adaptor Set 1 (supplied as single pieces) (parts 1 to 4 are included in VS2047.V2 kit)
2 VS2048.V2-02 Adaptor Set 2 (supplied as single pieces)
3 VS2048.V2-03 Adaptor Set 3 (supplied as single pieces)
4 VS2048.V2-04 Adaptor Set 4 (supplied as single pieces)
5 VS2048.V2-05 Fluid Measure (supplied as single pieces) (parts 5 and 6 are included in VS2046.V2 kit)
6 VS2048.V2-06 Bottle / Tube / Adaptor Assembly
6
5
3.3. Flexible Tube, Adaptors and Bottles (fig.1.1, 2, 3, 4 and 6).
These will provide a more accurate reading as the engine can be left running for longer.
3.3.1. Remove the return pipes from the injectors. Refer to the appropriate vehicle manufacturer's workshop manual.
3.3.2. Connect the appropriate, Bosch, Delphi or Denso adaptors to the flexible tubes.
3.3.3. Connect the flexible tubes to each injector and hang the bottle rack in a suitable position.
3.3.4. Start the engine (or crank over if it will not run), run until the one of the bottles is approximately 75% full, and stop the engine.
3.3.5. Check the levels for each injector. The overall variation in the levels should be less than 10%. Any injector which has a back leakage problem
will have more diesel in the tube.
3.3.6. Remove the tubes from the injectors, taking care not to spill any diesel, if possible lower the bottle rack to a level below that of the injectors
or raise the flexible tube, so that the fluid in the tubes drains into the bottles.
3.3.7. Refit the return pipes to the injectors as per the vehicle manufacturer's workshop manual.
NOTE: This system is designed to give a quick assessment of the return flow of the injectors, it is unable to determine all of the factors which may
affect the operation of the vehicle.