Sealey SM150D - Manual (Page 4)

6. MAINTENANCE
 WARNING! Ensure that the cut-off machine is unplugged from the power supply before attempting any maintenance.
6.1 Regularly clean the dust which accumulates inside the protective guards and on the external parts.
6.2 Periodically clean and oil the vice screw.
6.3 Change the cutting disc when it is worn and/or does not operate efficiently.
6.4 Before each use, check for obvious signs of damage to the machine. Also check for loose screws and other moving parts, incorrectly
mounted or misaligned parts and any other factors that might create an unsafe working environment.
 WARNING! Should excessive noise or vibration occur, cease use immediately. Turn off machine and disconnect from power supply. Do
not use the machine again until the problem has been fully resolved.
6.5. CHANGING THE MOTOR BRUSHES.
The motor brushes should be checked periodically for wear and renewed when worn down or pitted. The brushes can be accessed either
side of the motor casing as seen in fig.1.
6.5.1. Unscrew the plastic covers and withdraw the brush assemblies for inspection.
6.5.2. Insert the new brush into the keyway. Place the plastic cap over the head of the brush assembly and press the spring downwards. Screw
the caps back into position.
SM150D Issue: 3(SP) 10/12/13
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempston Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk, IP32 7AR
www.sealey.co.uk
W e b
email
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the EU Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. Contact your local solid waste
authority for recycling information.
Original Language Version © Jack Sealey Limited
5.2.5. Fit a new disc after having first inspected it for damage. DO NOT overtighten the clamping washer.
5.2.6. Refit and secure the static disc guard and the active disc guard. Refer to 5.1.1 for the testing proceedure after fitting a new disc.
Fig.4 Fig.6 Fig.5
Parts support is available for this product. To obtain a parts listing and/or diagram, please log on to
www.sealey.co.uk, email [email protected] or phone 01284 757500.