Technical specification 2. description, Content – Sealey SDM30 User Manual
Page 2

Others in the workplace should keep a safe distance from the drill, especially when it is in operation.
Keep the work area as childproof as possible by using padlocks and master switches.
Keep drill bits clean and sharp for best and safest performance. Follow the instructions for lubrication and changing accessories.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
Locate the drill in a suitable working area, keep area clean and tidy and free from unrelated materials. Ensure there is adequate lighting.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Secure non-stable work piece with a clamp, vice or other adequate holding device.
Avoid unintentional starting.
DO NOT force the drill to achieve a task it was not designed to perform.
DO NOT allow untrained persons to operate the drill.
DO NOT get the drill wet or use in damp or wet locations or areas where there is condensation.
DO NOT operate the drill if damaged.
DO NOT use drill in an area where paint fumes, solvents or flammable liquids pose a potential hazard. Keep flammable material away from
the drill when operating. Flammable waste, such as wiping or cleaning rags, must be placed in a closed metal container and disposed of correctly.
DO NOT exceed the rated capacity of the drill.
DO NOT operate the drill if any parts are missing as this may cause failure and/or personal injury.
DO NOT leave the drill operating unattended.
DO NOT operate the drill when you are tired, under the influence of alcohol, drugs or intoxicating medication.
DO NOT pull the cable from the power supply.
When not in use switch the drill off, remove plug from the power supply and do not leave until the tool has come to a complete stop.
3. TECHNiCal SpECiFiCaTiON
2. DESCripTiON
The SDM30.V2 variable speed bench drill is suitable for light industrial, agricultural and woodworking applications. The drill is fitted with a
flip-up safety guard and “No Volt Release” switch which prevents accidental restart after a mains power interruption. A rack and pinion feed shaft
with preset depth control for repetitive work is also included. Work clamps are also available for this drill, contact your local Sealey dealer for
information.
4. CONTENT
4.1. package content
Unpack the parts listed below and check to ensure they are in good condition. Any queries must be reported to your dealer immediately.
Head Assembly
Base
Chuck and Key
Column with Flange
Feed Handles and Knobs (3)
Table and Bracket
3 Bolts and Washers
Safety Guard
Hex. Keys (2)
Original Language Version
MODEl No:
SDM30
Drilling Capacity (Chuck Size):
13mm
Spindle Nose Taper:
MT2
Swing:
208mm
Spindle centre to column:
104mm
Spindle travel:
50mm
Number of speeds:
5
Speed range:
580-2650rpm
Maximum Distance Spindle to Table:
200mm
Maximum Distance Spindle to Base:
290mm
Working Table Surface size:
158 x 160mm
Working Base Surface size:
138 x 180mm
Overall Base Size:
200 x 305mm
Column diameter:
46mm
Collar diameter:
40mm
Overall Height:
580mm
Motor power:
185W - 230V
input power:
350W - 230V
Weight:
16kg
Optional Keyless Chuck 16mm:
N/a
SDM30.V2 Issue: 3 - 13/09/12