Sealey WD80 - Manual (Page 2)

5.1 Daily: check for damage and oil leaks.
5.2 Monthly: oil moving parts.
check for abnormal wear and tear.
With roller assembly at lowest point, check hydraulic oil level
by removing vent valve. top up, or allow to drain, as necessary.
replace vent valve.
5.3 to maintain peak performance of the wheel lift, periodically bleed the
hydraulic system. open the release valve by turning it anti-clockwise,
against spring pressure, and hold it open whilst pumping the foot pedal
four or five times. Allow release valve to close.
4. OPERATING INSTRUCTIONS
4.1 remove the transit plug at the back of the hydraulic unit between the
handles and replace it with the vent valve supplied. see fig.4.
4.2 set the position of the right hand roller to suit the size of wheel to be
removed / installed. see fig.3.
4.3 Lifting - raise the roller assembly by pumping the foot pedal up
and down through its full stroke until it reaches the correct height.
centre the trolley around the wheel, as close in as possible. When the
wheel has been released from the vehicle and is resting on the rollers
move the trolley out from the vehicle and adjust the slide bar and safety
rod to retain the wheel before lowering it. see fig.5.
4.4 Lowering - the release valve is spring loaded shut. the speed of
lowering is dependent on how far you open the valve. turn the valve
anti-clockwise, against spring load, for controlled lowering of the roller
assembly.
4.5 Transportation - Before moving a laden trolley ensure that the wheel
is centred on the rollers and adjust the slide bar and safety rod to retain
the wheel. Ensure that the roller assembly is fully lowered before
moving a wheel.
5. MAINTENANCE
6.1 roller assembly does not reach full height - low oil level, check and fill.
Bleed system as described in 5.3.
6.2 Pump ineffective - oil level too high, check and drain.
6. TROUbLE SHOOTING
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, suffolk Business Park ,
Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
email
Original Language Version WD80 Issue: 2 - 10/11/10
fig.4 fig.3
fig.5