Sealey GWC1200M - Manual (Page 2)

3.1. INSTALLING WINCH.
Most truck beds are not designed to support the pulling capacity of a winch. choose an appropriately strong winching point, which when fitted
will give the winch handle enough clearance to turn. We recommend that the fixing point is reinforced with steel plate. Ensure the fixing bolts
are adequate for securing the winch with a full load. the winch mounting point must be capable of withstanding 4 x the maximum rated
capacity of the winch.
for fixing dimensions see fig.1. for GWc1200M, GWE1200M and GWW1200M and fig.2. for GWc2000M, GWE2000M and GWW2000M.
3. INSTALLATION
Fig.1 Fig.2
3.2. CONNECTING THE CABLE.
3.2.1. Insert the steel cable through the hole (see fig.3) from inside to outside.
3.2.2. thread the cable out and in the four holes, back through the original hole and through one more. Ensure the end is inside and not
outside the drum.
3.3 CONNECTING THE STRAP.
3.3.1. the winch is designed to fit a strap as well as a cable. Push the strap fitting Bolt, through the belt loop in the direction of the arrow in
fig.4.
3.3.2. secure the strap fitting Bolt, with a spring washer and nut.

WARNING! the strap breaking strain must be at least 3 times the pulling capacity.
GWc1200BM,GWE1200M,GWW1200M,GWc2000M,GWE2000M,GWW2000M Issue: 2 (sp.) - 19/04/13 © Jack sealey Ltd
Original Language Version