Sealey ADT200 - Manual (Page 2)

4. operation
3. moUnting / assembly
4.1. With the jack fully lowered, remove existing fixed saddle from jack and fit the ADt200 in it's place. secure it with nut (9) and washer (8).
4.2. Adjust the pitch and tilt of the saddle to assist in safely supporting and transporting the transmission unit.
the cradle may be tilted forwards, backwards and from side to side, by operating the screw rod (6) and/or by turning the cradle on the
jack saddle.
4.3. Always position angle brackets (14) and angle plates (19) to best support and locate the transmission, ensure all nuts and bolts are
retightened. Before moving jack and transmission, ensure that restraint chain is in place and tensioned.
4.4. Periodically lubricate the cradle pivot points and the adjusting bolts.
 Warning! failure to assemble the cradle correctly may result in serious damage and/or personal injury.
unpack the product and check contents against the parts listed. should there be any damaged or missing parts contact your supplier
immediately.
note: Items (2, 3, 4, 6, 10, 11) and (1, 5, 4) are pre-assembled.
3.1. remove one nut (10) from screw rod (6), and thread screw rod (6) through shaft (5), re-fit nut (10).
Position saddle base (1) underneath saddle plate (2) and thread pivot shaft (12) through from one side ensuring a collar (7) is
inserted either side of the saddle base (1) and inside of the saddle plate brackets. secure with a circlip (13) at each end of pivot
shaft (12). the three nuts (10) should be positioned near the end of the screw rod (6) closely fitted either side of the shaft (5) and
locked onto the screw rod (6) by tightening the grub screws (11).
3.2. Attach angle brackets (14) to the saddle plate (2) with long bolts (15), washers (16) and nuts (17).
3.3. Attach angle plates (19) to angle brackets (14), using bolts (20), washers (18) and nuts (17).
3.4. Attach chain (27) to one angle plate (19) with bolt (21), washer (22) and nut (23).
3.5. Attach hook pin (24) to one angle plate (19) with washer (18) and nut (17).
3.6. Attach hook (25) to the hook pin (24) with washer (22) and wing nut (26).
item description
1 saddle Base
2 saddle Plate
3 shaft
4 circlip
5 shaft
6 screw rod
7 collar
8 Washer
9 Bolt
10 nut
11 Grub screw
12 Pivot shaft
13 circlip
14 Angle Brackets
15 Bolt
16 Washer
17 nut
18 Washer
19 Angle Plate
20 Bolt
21 Bolt
22 Washer
23 nut
24 Hook Pin
25 Hook
26 Wing nut
27 chain
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
inFormation: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
sole Uk distributor, sealey group,
Kempson Way, suffolk Business
Park , Bury st. Edmunds, suffolk,
IP32 7Ar
www.sealey.co.uk
Web
email
Original Language Version ADt200 Issue no: 1 - 29/01/10