Sealey PBS99/10 - Manual (Page 2)

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
We, the sole importer into the UK, declare that the products listed below are in conformity with the following standards and
directives.
The construction file for these products are held by the Manufacturer and may
be inspected, by a national authority, upon request to Jack Sealey Ltd.
For Jack Sealey Ltd. Sole importer into the UK of Sealey Quality Machinery.
Signed by Mark Sweetman 10th March 2009
Declaration of Conformity
HYDRAULIC PIPE BENDERS
MODELS:
PBS99/10.V3 & PBS99/14.V3
2006/42/EC Machinery Directive
93/68/EEC CE Marking Directive
01284 757500
01284 703534 [email protected]
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
email
PBS99/10.V3 & PBS99/14.V3 Issue No. 2 - 10/03/09
3.2. With the hydraulic unit release valve open and the ram fully retracted, fit the appropriate sized die to the
ram.
3.3. Move pipe rollers and shafts to appropriate holes in frame and ensure that shafts are properly fitted and
secured using hitch pins.
3.4. Introduce the pipe between die and rollers, positioning it so that the centre of the required bend in the pipe
is over the centre of the die.
Note! Consider packing the pipe or tube with dried sand or similar medium before bending as this may
help to alleviate deformation of the pipe or tube. Pack the sand tight and cap the ends.
3.5. Close release valve and pump handle until the required degree of bend is achieved.
3.6. Using the end of the handle, open the release valve and ram will retract under spring tension.
3.7. Annually, replace hydraulic oil using Sealey Hydraulic Jack Oil. With ram fully down, drain and refill to
bottom of filler plug hole.
PBS99/10.V3
PBS99/14.V3
1
1
2
2
Fig.1