Fig.2, Maintenance – Sealey YK15BP User Manual
Page 3
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
5. MAINTENANCE
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE PRESS.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN PRODUCT TO US. Please telephone us on 01284 757500 to obtain the address and phone number of your local agent.
If product is under guarantee please contact your dealer.
De-commissioning Product
Should the product become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of the
product and the oil according to local regulations.
Note: Maintenance and repair must only be carried out by qualified person. Contact your Sealey dealer for details.
5.1
Always keep the press clean, dry and lubricate all moving parts at regular intervals.
5.2
When not in use always store in a dry location with the ram head retracted.
5.3
Should you need to check or replace oil ensure the ram head is fully retracted. Remove the oil reservoir filler plug and top up using
Sealey hydraulic jack oil (Sealey ref: HJO500MLS or HJO5LS).
DO NOT use brake fluid. After filling purge the system to remove any
air.
4.2
SETTING THE WORKING TABLE HEIGHT
4.2.1 To set the working table at the desired height it is advisable to obtain assistance due to the weight of the working table. Remove the
pressing plate/V-blocks from the working table then remove the safety clips and the pins. Position the working table at the required
operating height, insert the pins into the appropriate holes in the uprights and fit safety clips.
4.3
OPERATING INSTRUCTIONS
4.3.1 Check that the release valve on the hydraulic unit is fully closed, ready for operation (fig.2).
4.3.2 Locate the flat pressing plate/V-blocks on to the working table, push down the locating pins to ensure the plates do not slip. Place
workpiece on to the plates and position the head of the hydraulic unit over the centre of the workpiece.
Note: Care must be taken to
ensure the plates do not fall from the working table.
WARNING! DO NOT apply off-centre loads.
4.3.3 Rotate the speed control valve clockwise to the 'Quick Without Load' position (fig.2) to bring the ram head rapidly into contact with the
workpiece. Once the ram head has made contact with the workpiece, rotate the speed control valve anti-clockwise to the 'Slow With
Load' position (fig.2) for more controlled pressing with full load capacity.
Note: The 'Quick Without Load' setting will only operate to
approximately 2tonne of load. Monitor the pressure gauge during operation to ensure that the rated capacity of the press is not
exceeded.
4.3.4 When work is complete turn the release valve anti-clockwise (fig.2) to release the pressure. The piston and the ram head will retract
automatically.
Note: Always keep the ram head retracted after use.
Original Language Version
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
Web
YK15BP Issue No: 1 - 14/10/11
fig.2