Sealey DF760 User Manual
Df760.v2, Model no, Bench mounted sheet metal bender

3
Wear approved safety goggles when operating the sheet metal bender. Your local Sealey dealer offers a complete range of safety equipment.
3
Use the tool only for its intended purpose.
3
Check all items of the sheet metal bender regularly for damaged parts.
DO NOT use if any of its components are broken, worn or damaged.
3
Use original Sealey spare parts and accessories. Use of non-recommended spare parts may be dangerous and will invalidate warranty.
7
DO NOT operate this tool while tired, under the influence of drugs, alcohol or other impairing medication.
7
DO NOT allow unqualified persons to operate the metal folder. Keep children away from the tool.
1. SAFETY INSTRUCTIONS
Bench mounted sheet metal folder, fitted with mounted plates. Capable of bending up to 17 gauge steel sheet. Ideal for the small garage or
restoration operation.
Maximum sheet size:
Maximum sheet thickness:
Maximum bending angle:
Length of unit:
Width of unit:
Height of unit:
Unpack the unit and check that all parts are included and not damaged. Should you experience a problem contact your supplier immediately.
Note: Numbers in brackets refer to item numbers on the parts diagram.
2.1 The stand (1) should be secured to a work bench using the mounting holes and 4 bolts (3/8” diameter).
2.2 Each handle ball (7) should be attached to the handle lever (6) and the handle levers should be placed into the pins (5).
2. ASSEMBLY
3. OPERATION
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
INSTrUCTIoNS For:
BENCH MOUNTED SHEET METAL BENDER
MoDEL No:
DF760.V2
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No responsibility is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date. Proof of purchase will be required for any claim.
INFORMATION: Please call us for a copy of our latest catalogue.
3.1 To use the bender, lower the handle lever until the moving plate is parallel to the work bench. Position the material to be bent on the
supporting plate (2) and the moving plate (4) and properly align with the edge to be bent up against the back edge of the supporting plate.
3.2 Place and secure the pressing plate (3) on top of the supporting plate with the back edge of pressing plate aligned with back edge of
supporting plate. Suitable clamps (not included) are required to secure the pressing plate. For a full range of clamps see your
authorised Sealey dealer.
3.3 raise the two handle levers to bend the material to the desired angle.
3.4 When the folder is not in use, it should be covered and stored in a dry location.
Item Part No.
Description
1
DF760.V2-01
Stand Complete (includes items 1, 2, 4 & 5)
3
DF760.V2-03
Pressing plate
6
DF760.V2-06
Handle lever
7
DF760.V2-07
Handle knob
4. PARTS
DF760.V2
Issue No: 2 - 30/01/09
760mm
17gauge
90 degrees
800mm
150mm
73mm
01284 757500
www.sealey.co.uk
01284 703534
Sole U.K. Distributor
Sealey Group
Bury St. Edmunds
Suffolk.
Web