Introduction & specifications, Recommended fuse rating: 3 amp – Sealey CP5418V User Manual

Page 2

2. INTRODUCTION & SPECIFICATIONS

Lightweight and compact design. Features heavy-duty alloy bevel

gear head with aluminium gear casing and adjustable grinding disc

guard. Features spindle lock for quick disc changes. Supplied with

side handle and soft grip body for added comfort and control.

density level with a flat discharge curve - performing better and

longer than a conventional Ni-CD/Ni-MH battery. No memory effect

allows the battery to recover from a deep discharge with no tendency

to reduce overall capacity. Supplied with 1 hour mains charger, two

batteries, pinned wrench, hex key and canvas storage bag.
Model No: ............................................................................. CP5418V

Battery type: ...............................................................Li-ion 18V 1.3Ah

Disc Size: ...............................................................................Ø115mm

Spindle Thread Size: ..................................................................... M10

Motor Power: ............................................................................... 800W

No Load Speed: ..................................................................... 7000rpm

Noise Power: ...................................................................... 87.67dB(A)

[Certainty value] (K):.................................................................. 3dB(A)

Noise Pressure: .................................................................. 76.67dB(A)

[Certainty value] (K):.................................................................. 3dB(A)

Replacement battery: ....................................................... CP5418VBP

Weight (including battery): ............................................................3.5kg

battery. For safety and environmental reasons

DO NOT discard

in domestic waste or by burning. ONLY discard or recycle

according to local authority regulations.



WARNING! DO NOT allow a leaking battery to contact your

person. If you come into contact with battery liquid take the

following immediate action:



a) Skin contact: Wash immediately with soap and water,

then wash flesh in either lemon juice or vinegar.



b) Eye contact: Wash with a strong solution of boric acid,

and seek immediate medical attention.

Original Language Version

CP5418V | Issue: 3O - 28/01/15

Depress buttons to

remove from grinder

Latch

Red LED

Green LED

Red LED

Amber LED

Green LED

Press to check

battery status.

View on rear of battery

Charger base, battery fully engaged

Press to lock

gearbox

I/O Switch.

Fit handle either side

Slide on fully, depress buttons to slide off

RECOMMENDED

FUSE RATING:

3 AMP

fig.1

1.4 Wiring a BS 1363/A UK 3 Pin Plug

If in doubt contact a qualified electrician.

a) Connect the GREEN/YELLOW earth wire to the earth

terminal ‘E’.

b) Connect the BROWN live wire to the live terminal ‘L’.

c) Connect the BLUE neutral wire to the neutral terminal

‘N’.

d) After wiring, check that there are no bare wires, that

all wires have been correctly connected, that the cable

outer insulation extends beyond the cable restraint and

that the restraint is tight.

Double insulated products, which are always marked with this

symbol , are fitted with live (brown) and neutral (blue) wires

only. To rewire, connect the wires as indicated in diagram.

DO NOT connect either wire to the earth terminal.

Grinder profile, battery fitted, grinding disc not fitted

fig.2

fig.3

fig.4

fig.5

fig.6