Sealey RE97XC02 - Manual (Page 2)

p p WARNING! Ensure you have read and understood chapter 1
safety instructions.
Note: These instructions are intended to provide a guide to the basic
operation of the kit and are in no way intended to replace the
advice/instruction of a qualified specialist.
Only fully trained persons should use this equipment.
4.1 Remove plug from ram connector (retain plug to reseal connector
after use).
4.2 Connect to suitable hydraulic pump (see section 3).
4.3 Position the ram as required and operate the pump.
IMPORTANT: Always store the ram with the piston fully retracted to help prevent corrosion (not applicable to pull rams, the pistons of which
should be coated in jack oil before storage). Rams with signs of rust on the main piston cannot be replaced under warranty.
3. INTRODUCTION
Comprehensive set of mini, midi and maxi sized push and pull rams. Suitable
for many applications including workshop, agricultural, industrial and
construction where lifting, pushing positioning, bending and holding heavy loads
may be required. Use in conjunction with 610/40 or 604/40 Hydraulic pump and
610/42 or 604/42 hose (not supplied). Supplied in a steel carry case.
Only fully trained and qualified persons should use this equipment. It is very
important that the user understands the applications, limitations and specific
hazards of the product.
RE97XCM05 with hooks fitted
RE97XCM02 with hooks fitted.
4. INSTRUCTIONS FOR USE
5. MAINTENANCE
IMPORTANT: Only fully qualified personnel should attempt maintenance or repair to the hydraulic system.
p p WARNING! DO NOT use brake fluid, or any fluid other than hydraulic jack fluid, as this may cause serious damage to the ram and will
invalidate the warranty! Use only Sealey hydraulic oil.
5.1 General
Before each use check for broken, cracked, bent, or loose parts, or any visible damage to welds, ram, pump, hose and accessories.
If any suspect item is found remove from service and take necessary action to remedy the problem.
Replace/repair with genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
Keep all parts of the kit clean - use only a mild detergent and a damp cloth. DO NOT use solvents.
Note: A small amount of oil around ram seal is normal - a thicker layer of oil may be deposited onto the ram initially, due to the ram
seals bedding in.
Hydraulic couplings will weep a small amount of oil, particularly if ram is under pressure when coupling is released - this is
normal.
IMPORTANT: NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THE RAM.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK.
DO NOT RETURN RAM TO US. Please telephone us on 01284 757500 to obtain the address and ‘phone number of your local agent.
If product is under guarantee please contact your dealer.
De-commissioning Hydraulic Ram
Should the ram become completely unserviceable draw off the oil into an approved container and dispose of the product and the oil according
to local regulations.
Declaration of Conformity
We, the sole importer into the UK, declare that the product listed below is in conformity with the following standards and directives.
SPECIALIST PUSH AND PULL RAM SET
Model: RE97XCKIT
98/37/EC Machinery Directive
93/68/EEC CE Marking Directive
1st November 2004 Signed by Mark Sweetman
The construction file for this product is held by the Manufacturer and may be inspected, by a national
authority, upon request to Jack Sealey Ltd.
For Jack Sealey Ltd.
Sole importer into the UK
of Sealey Power Products.
Sole UK Distributor,
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 757500 01284 703534
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product. WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required
for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
RE97XCKIT - 1 - 051104
[email protected] www.sealey.co.uk
e-mail Web