Sealey SA17/S - Manual (Page 2)

2. INTRODUCTION & SPECIFICATION
Recommended hook-up is shown in fig. 1.
3.1. Ensure that the polisher air valve (or throttle) is in the "off" position before connecting to the air supply.
3.2. You will require an air pressure between 70-90psi, and an air flow according to the specification above.
3.3.  WARNING! Ensure that the air supply is clean and does not exceed 90psi while operating the polisher.
Too high an air pressure and/or unclean air will result in excessive wear and may be dangerous, causing
damage and/or personal injury.
3.4. Drain the compressor air tank daily. Water in the air line will damage the polisher and invalidate your
warranty.
3.5. Clean compressor air inlet filter weekly.
3.6. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres).
The minimum hose diameter should be 1/4” I.D. and fittings must have the same inside dimensions.
3.7. Keep hoses away from heat, oil and sharp edges. Check hoses for wear, and make certain that all
connections are secure.
3.8. Vibration may cause failure if a quick change coupling is connected directly to the air polisher. To
overcome this, connect a leader hose to the polisher. A quick change coupling may then be used to
connect the leader hose to the air line recoil hose. See figs. 1 & 2.
3. AIR SUPPLY
fig. 1
Pad Size . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Ø180mm
Thread Size . . . . . . . . . . . . . . . . . . . . . . . . . . 5/8”UNC
Free Speed Loaded/Unloaded . . . . . . . . . . . . 2500rpm
Max. Operating Pressure . . . . . . . . . . . . . . . . . . . 90psi
Air Consumption. . . . . . . . . . . . . . . . . . . . . . . . . 5.3cfm
Air Inlet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1/4”BSP
Noise, Power . . . . . . . . . . . . . . . . . . . . . . . . 99.78dBA
Noise Pressure. . . . . . . . . . . . . . . . . . . . . . . 88.78dBA
Vibration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.09m/s 2
Uncertainty . . . . . . . . . . . . . . . . . . . . . . . . . 0.4254m/s 2
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2kg
Polished and well balanced aluminium body with two side-handle mounting positions. Precision made bevel
gears give quiet and smooth operation. Trigger operated throttle control. Suitable for polishing and
compounding.
fig. 2
Original Language Version
SA17/S.V2 Issue: 3(SP) - 17/10/13 © Jack Sealey Limited